NEWS CENTER

Surface Treatment Before Metal Die Casting Operation

2019-11-01 10:37

Before the hardware is die-casted, the surface should be treated to achieve no oil, rust and impurities, because the surface is usually covered with rust, scale, slag or dust during storage and transp

nuowei

 

Before the hardware is die-casted, the surface should be treated to achieve no oil, rust and impurities, because the surface is usually covered with rust, scale, slag or dust during storage and transportation. There are many ways to deal with the surface of the dirt, and I will give you a detailed introduction today.
 
    1. Mechanical treatment method: This method mainly includes shot peening, shot blasting and polishing, etc. It is also the most used cleaning method in the metal die casting factory. The shot blasting method uses centrifugal force to accelerate the projectile and throw it onto the surface of the workpiece. The method of cleaning the rust is carried out; the polishing method is familiar to everyone, and it is a method of removing the scale of the surface by performing high-speed rotation on the surface under the action of the motor.
 
    2.manual processing: This method is mainly manual work, and the tools used mainly include grinding wheels, wire brushes and scrapers. This method can remove the scale and rust on the surface of the workpiece, but this method is labor intensive, the work efficiency is very low, and the cleaning is not very clean, so many hardware die-casting manufacturers rarely take it. This method is gone.
 
    3. Chemical treatment methods:It is mainly a method in which a basic or acid-alkaline solution is used to make contact with the surface of a metal die-casting part, thereby generating a series of chemical reactions to remove the dirt on the surface.
 
    The most common surface treatment methods for metal die-casting parts are the above three. You can choose the appropriate processing method according to the actual situation. The purpose of using these methods is to ensure that the surface of the metal die-casting parts is clean and free of residues such as acid and alkali. There is also no adhesion of impurities and the like.
 
 
 
Copyright statement: The content of the article is extracted from the network. If there is any infringement, please contact us to delete it!

Other news

Gravity casting series mold design and product processing

2023-09-14 12:41

Summarize: 1. Before processing, it is necessary to detect the hardness of the body, stretch the test rod, and confirm that it is qualified before processing 2. Castings are tested for Brinell hardness according to ISO 6506-1, and the control range is above 85HB 3. The castings have been inspected by radiographs and conform to the third-level standard of ISO10049 4. The thickness of the coating must be 80-100 microns 5. Castings are subjected to salt spray test for 24 hours according to is09227 / astm b117, to ensure that no red rust is observed at the end of the salt spray test, once for each batch The spray masking tool needs to be re-customized

See more information
< 1234...36 > proceed page

HEADQUARTER ADD

904-905, China-base Building, No.666, Tiantong South Road, Ningbo 315100, China

AUTOMOTIVE DIVISION Add

NO. 45, Baofeng Road, Eastern Suburb Development Zone, Fenghua 315500, China

ALUMINUM FORGING DIVISION ADD

Shaojiadu Street, Linhai City,Zhejiang Province 317000, China

INNOVAW LPDC/GPDC division

No. 288, Fengchuan Avenue, Tonglu, Hangzhou, Zhejiang, China

Copyright 2022 Inc. All rights reserved.